Thingiverse
Patio Umbrella Stand Cap
by dereksrose
1
Downloads
0
Likes
0
Makes
When we took down our patio umbrella for the season my wife suggested that I design and print a cap for its stand to keep all the leaves and pine needles out over winter.
That only took a few minutes... so I kept designing. I ended up mocking up a miniature version of the umbrella because [TBD]. The angles of the umbrella don't lend themselves to easy printing, but I also didn't try very hard.
Our umbrella stand has a diameter of 43.25mm. There are two lock pins that are 9.35mm in diameter and 33..95mm from the top of the pipe.
That only took a few minutes... so I kept designing. I ended up mocking up a miniature version of the umbrella because [TBD]. The angles of the umbrella don't lend themselves to easy printing, but I also didn't try very hard.
Our umbrella stand has a diameter of 43.25mm. There are two lock pins that are 9.35mm in diameter and 33..95mm from the top of the pipe.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!