Thingiverse
Pattern Weight from Washers
von kyle_marsh
105
Downloads
91
Likes
0
Makes
I had some steel fender washers (inner diameter 0.25", outer diameter 1.25") and wanted to use them as weights for sewing patterns, so I whipped up this design in Fusion360 to make a little holder for them. Each holder fits 4 of washers I have. Be warned: It's a tight fit and you're unlikely to get your washers back without destroying the print.
I designed this to be printed at 0.2mm layer height and 0.5mm extrusion width.
I designed this to be printed at 0.2mm layer height and 0.5mm extrusion width.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
