Slicer Discord
PAXPACKER – 3D printable model from Thingiverse Thingiverse

PAXPACKER

145 Downloads
98 Likes
2 Makes
Go to Model
OK, I admit I like weed and that's a good thing cause I'm Canadian !

So here's a little gadget I designed in order to pack the best and most dense weed pucks that fit straight into your PAX 2 or 3 herb vaporizer.

Just fill the receiver cup, and then push the weed down the funnel with your finger. Once the weed is in, just insert the pusher and then squeeze both parts with your hand (or push it on a hard surface (if you're a wimp). Apply pressure until the weed is fully compressed. Remove the end cap, insert end of the funnel in the PAX herb oven and give it one last push with the pusher, you'll hear a "clic" which means your PAX is locked and loaded for your next session.

The puck size is optimized to allow airflow around the weed puck for the best and most efficient puff ever.

Enjoy !
Source
Thingiverse
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

Montrealer also publishes on

1 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection