Thingiverse
PayWear cuff bracelet
door NMedlock
3
Downloads
3
Likes
0
Makes
Westpac bank (one of the top four banks in Australia) now offers a series of wearables that can allow you to pay with your debit card.
Looking through the information on the [new wearable](https://www.westpac.com.au/personal-banking/mobile-wallets/paywear/) and [the accessories](https://www.paywearaccessories.com.au/home/) that they offer, I decided that I could design and print something I would like to wear for much cheaper.
This is my third iteration of a cuff bracelet that can accept two of the PayWear cards and should fit most adults as it can be slipped over the wrist.
The PayWear cards themselves seem to be following the form factor of a standard SIM (25mmx15mm), so this design could be used to carry two standard SIM if you needed.
Looking through the information on the [new wearable](https://www.westpac.com.au/personal-banking/mobile-wallets/paywear/) and [the accessories](https://www.paywearaccessories.com.au/home/) that they offer, I decided that I could design and print something I would like to wear for much cheaper.
This is my third iteration of a cuff bracelet that can accept two of the PayWear cards and should fit most adults as it can be slipped over the wrist.
The PayWear cards themselves seem to be following the form factor of a standard SIM (25mmx15mm), so this design could be used to carry two standard SIM if you needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!