PC Fan Controller Box 3.5"

Very good design by Aussie_ben, thanks for sharing it!

I remixed slightly to make a fully enclosed box for my Vantec Nexus Fan Controller - I'm using it for my 40mm fans on the stepper motors, so wanted it enclosed.

Using Sketchup, I literally sliced/copied the one full side of the box, flipped the orientation and attached to the open side of the box. I moved the middle screw holes on each side by 5mm towards the back so the controller front would fit flush.

A bit of a tight fit, but it fits nonetheless. If I were to print again, I would scale up by 1%.

NOTE:
- I've included the SKP file I used.
- "Fan Controller Cover.stl" - this is the file I printed via Simplify3D using an SD Card
- "Fan_Controller_Cover_Fixed_MakePrintable.stl" - I ran the above file though Make Printable, as Cura/Sl1cer seemed to find errors. Check your preview before printing.