Thingiverse
PC Power Button Cover
von Zigma51
24
Downloads
16
Likes
0
Makes
This is sized to work on my Be Quiet! Dark Base Pro 900 Silver rev. 2
Will work on other cases but you might need to resize it yourself.
**Do not use glue to stick this to your computer**
I recommend to use 2mm PET Acrylic Clear Double-Sided Super Tape to stick this to your case.
If you resize it in Tinkercad, remember to hold shift and drag a corner to right size.
I have good luck printing with and without supports. If you are printing the smaller cover, supports are not needed. I did have a few fail prints of the 44.5mm cover without supports.
TinkerCad Link
https://www.tinkercad.com/things/bJYqgiiDCH0
This is a remix from
Hinge box with a premounted lid (Print at once)
by AhmetCelikPhd November 25, 2015
https://www.thingiverse.com/thing:1155457
Will work on other cases but you might need to resize it yourself.
**Do not use glue to stick this to your computer**
I recommend to use 2mm PET Acrylic Clear Double-Sided Super Tape to stick this to your case.
If you resize it in Tinkercad, remember to hold shift and drag a corner to right size.
I have good luck printing with and without supports. If you are printing the smaller cover, supports are not needed. I did have a few fail prints of the 44.5mm cover without supports.
TinkerCad Link
https://www.tinkercad.com/things/bJYqgiiDCH0
This is a remix from
Hinge box with a premounted lid (Print at once)
by AhmetCelikPhd November 25, 2015
https://www.thingiverse.com/thing:1155457
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
