Thingiverse
PC4-M10 Filament Filter
door Foppemoa
29
Downloads
16
Likes
0
Makes
A filament filter that snaps on to a PTFE tube, using a PC4-M10 coupler.
Put a small piece of foam inside of it and ram a pointy piece of filament through the entire filter several times.
This is to form a hole and remove any chunks of foam that you ripped out with the filament.
For easier insertion you might want to chamfer the end of the PTFE tube.
Put a small piece of foam inside of it and ram a pointy piece of filament through the entire filter several times.
This is to form a hole and remove any chunks of foam that you ripped out with the filament.
For easier insertion you might want to chamfer the end of the PTFE tube.
Foppemoa publiceert ook op
85 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!