PCB Holder with Magnets

Update:

I added the single magnet design, that allows you to cluster around almost any board shape.

You'll need two of course.
I made it for .062 PCB material, but you can remix it and open the slots.

I have made other PCB holders for assembly and used guide pins. They work ok, but the guide pins limit the board size.
This one uses magnets so you can use a cheap piece of sheet steel and hold just about any PCB, until it flexes. The magnets also let you grasp the PCB board at odd angles.
I used the same 15mm x 4mm magnets I used for my
Tubing Cutter ( https://www.thingiverse.com/thing:2570935 ) and the
HF flashlight belt clip ( https://www.thingiverse.com/thing:2617329 ).


Magnet: https://www.ebay.com/itm/311833824652?var=610692315668

I made one that used thin flat magnets from old antennas, but the magnet pull was much better then the glue. This one uses 6-32 flatheads and they self tap. They're not coming out.