Thingiverse

PCB Needle Workstation

by GatCode

5 Downloads

3 Likes

0 Makes

This is a tiny base for the "PCB Workstation with Needle-Probes" from [giufini](https://www.thingiverse.com/giufini). It is designed to work with these cheap pcb holders like you can see in the image. You may need to drill two holes in the metal of the holder and also put some isolation tape in the brackets to isolate the pcb you want to test. Also you may want to print the base a bit bigger than usual to ensure a tight but not too tight fit (approx 102%).

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

Polycarbonate

Software

Cura, PrusaSlicer, or similar

Same designer, more platforms

GatCode also publishes on

17 additional models across 1 more platforms

Printables

17 models

♥ 227 ↓ 1,156 ⚒ 6

No ratings yet

No comments yet – be the first!

PCB Needle Workstation

Add to Collection