Thingiverse
PCB Spacer
door biglouie
1
Downloads
1
Likes
0
Makes
PCB Spacer for old arcade boards )or new ones maybe!)
The design allows me to unscrew the spacers that usually hold the board together and replace with these while I work on them.
The little nipple on the inside of the slots allows the spacers to clip into the existing screw holes in the PCB to hold them loosely in place, without falling out.
The hole at the top allows for the design to stack, so you can add to the spacer if you have a 3 or 4 stack board. Just clip the bottom nipple, into the top hole. There is a 0.15mm clearance offset. Printers vary, so that may not be enough.
Quick and easy, allows access without constantly having to remove screws.
6 will print in about an hour for me.
@robllewellynuk - Instagram
The design allows me to unscrew the spacers that usually hold the board together and replace with these while I work on them.
The little nipple on the inside of the slots allows the spacers to clip into the existing screw holes in the PCB to hold them loosely in place, without falling out.
The hole at the top allows for the design to stack, so you can add to the spacer if you have a 3 or 4 stack board. Just clip the bottom nipple, into the top hole. There is a 0.15mm clearance offset. Printers vary, so that may not be enough.
Quick and easy, allows access without constantly having to remove screws.
6 will print in about an hour for me.
@robllewellynuk - Instagram
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!