PCB800099-v9 Housing

v 1.0:

Because this PCB board controls several different sized LCDs, I isolated the PCB case and modified it slightly to address a couple of issues:

1. The ribbon cable now has room without concerns about it getting pinched/damaged.
2. I raised the walls by 2mm to allow the addition of a lid.

I would recommend adding some breathing holes so heat can escape; electronics can get warm, and my LCD setup will be in my car, so having air pass over everything may be desired. Since I already printed mine, I just drilled some holes into it to address the heat.

V1.2:

I updated the enclosure with vent holes, as well as a spot for the power-supply wire to enter. I also made a lid.

I've been told that my STL files are a little messy (I'm still learning Blender), but that Cura seems to like them just fine.

I printed both the new version (1.2) and the lid on their sides to reduce warping when printing in ABS. I also used a raft.