Thingiverse
PCBite Probe Holder Base
by clintfisher
6
Downloads
2
Likes
0
Makes
I LOVE my PCBite probes! There's just no place to safely put those super-sharp probe tips though!!
Why not put a probe holder on the base of the probe itself?
PRINT UPSIDE-DOWN for no-support printing.
I used Prusament PLA with a 0.25mm layer height.
NOTE: This is a fairly snug fit by design. If it's loose, it's harder to pick up and move.
If it's too tight for your bases, maybe scale by about 100.025% - 100.05% to add about 0.1mm to the diameter where the magnet fits. Remember: You don't want it loose.
TO REMOVE: Lay horizontally on solid flat surface. With one hand, pinch the gooseneck about 8mm from the holder and push straight towards the holder being held by the other hand.
Why not put a probe holder on the base of the probe itself?
PRINT UPSIDE-DOWN for no-support printing.
I used Prusament PLA with a 0.25mm layer height.
NOTE: This is a fairly snug fit by design. If it's loose, it's harder to pick up and move.
If it's too tight for your bases, maybe scale by about 100.025% - 100.05% to add about 0.1mm to the diameter where the magnet fits. Remember: You don't want it loose.
TO REMOVE: Lay horizontally on solid flat surface. With one hand, pinch the gooseneck about 8mm from the holder and push straight towards the holder being held by the other hand.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
