Thingiverse
pdc004 decoy shell
by DanPapa
0
Downloads
0
Likes
0
Makes
The hole fits if drilled to 14mm.
The front plate dia is 17mm.
The reason for extending the lower rear part is to prevent it from slipping inward by securing it with a small screw bolt.
The screw line is designed at over 45 degrees to ensure proper printing without the supports.
Print with 100% infill.
The front plate dia is 17mm.
The reason for extending the lower rear part is to prevent it from slipping inward by securing it with a small screw bolt.
The screw line is designed at over 45 degrees to ensure proper printing without the supports.
Print with 100% infill.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!