Thingiverse
PDW Bindle Seatpost Mount
door aiber
11
Downloads
11
Likes
0
Makes
Pulled dimensions off of the PDW bindle seatpost mount hardware. Interestingly enough, the pieces are in fact not the same width, by about 1 mm. I preserved this irregularity.
I included scans of the actual pieces to try & match other dimensions.
I'm not talking about the faces adjacent to the seatpost interface. That's supposed to be that way.
Requires 2 M6 x 1 bolts, about 30-45 mm in length. Supposed to support seatposts from 22.0 - 31.6 mm in diameter.
I think the binding post bolt is an M5 x 0.8, & the post is 35 mm long.
I don't recommend this for 3D printing, but for machining.
I included scans of the actual pieces to try & match other dimensions.
I'm not talking about the faces adjacent to the seatpost interface. That's supposed to be that way.
Requires 2 M6 x 1 bolts, about 30-45 mm in length. Supposed to support seatposts from 22.0 - 31.6 mm in diameter.
I think the binding post bolt is an M5 x 0.8, & the post is 35 mm long.
I don't recommend this for 3D printing, but for machining.
aiber publiceert ook op
186 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
