Thingiverse
Peach Chest
von 3DTwinkie
58
Downloads
49
Likes
1
Makes
This is my Peach Chest inspired from Paper Mario 64. The chest that appears in the castle that peach can throw badges into.
This chest prints in 5 main parts:
Top Lid, includes notches for the outer panels
Bottom Box, includes notches for the outer panels
Top Panels, 4 rolls
Bottom Panels, 1 for each side. The shorter panel goes on the back
Front Star, has an indent on the bottom box
The top and bottom connect via open hinge design that allows a 1.75mm filament strand to fit through, so grab some extra filament and push it through.
Everything here prints without supports, on a standard 0.4mm nozzle and 0.20mm layer height.
This chest prints in 5 main parts:
Top Lid, includes notches for the outer panels
Bottom Box, includes notches for the outer panels
Top Panels, 4 rolls
Bottom Panels, 1 for each side. The shorter panel goes on the back
Front Star, has an indent on the bottom box
The top and bottom connect via open hinge design that allows a 1.75mm filament strand to fit through, so grab some extra filament and push it through.
Everything here prints without supports, on a standard 0.4mm nozzle and 0.20mm layer height.
3DTwinkie veröffentlicht auch auf
122 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
