Peacock X-Ray

An x-ray of a peacock. Print at 100% infill with a layer height of 0.2mm with a base layer of 0.32mm Use any colors you'd like, either via AMS or by manually swapping filaments as indicated below Filaments Used:PLA BambuLab Matte Charcoal Transmission Distance: 0.8PLA SPARKLE BambuLab Slate Gray Sparkle Transmission Distance: 6PLA BambuLab Matte Ash Gray Transmission Distance: 15PLA BambuLab Basic Jade White Transmission Distance: 3 Swap Instructions:Start with CharcoalAt layer #4 (0.92mm) swap