Thingiverse
Peak Design Compatible Camera Clip / Anchor
2
Downloads
0
Likes
0
Makes
This clip is an exercise in designing parts for specific process of manufacturing and you probably should not blindly trust it with your expensive camera!
! WEIGHT TEST BEFORE USE ! USE AT YOUR OWN RISK !
BUILD STEPS:
* 1 - PRINT : 100% Fill and high nozzle temp
* 2 - POST-PROCESS : Clean up the bottom faces and drill out the hole with 1.2MM drill
* 3 - ATTACH THE LANYARD : Fill the Pocket with JB-Weld (or other 5min resin) . Insert the the chord (if you are not using a loop MELT THE ENDS TOGETHER!) than insert 1mm steel pin (wire) through the Small hole
* 4 - Clean any squeeze-out resin and let it fully cure for 24 hr
! WEIGHT TEST BEFORE USE ! USE AT YOUR OWN RISK !
BUILD STEPS:
* 1 - PRINT : 100% Fill and high nozzle temp
* 2 - POST-PROCESS : Clean up the bottom faces and drill out the hole with 1.2MM drill
* 3 - ATTACH THE LANYARD : Fill the Pocket with JB-Weld (or other 5min resin) . Insert the the chord (if you are not using a loop MELT THE ENDS TOGETHER!) than insert 1mm steel pin (wire) through the Small hole
* 4 - Clean any squeeze-out resin and let it fully cure for 24 hr
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
