Thingiverse
peco turnout servo mount with microswitch support
door PhantomRC
3
Downloads
2
Likes
0
Makes
This is a remix of the original thing from Doc Nielsen (https://www.thingiverse.com/thing:6559980) but with two modifications:
1. a revised gear with smaller inner diameter for use on cheap MG90S servo.
2. addition of support for 01 microswitch (use double-side tape or 2mm self tapering screws to attach the MS).
3. this design is on the data of the OMRON SS-5GL micro switch.
The linear bar is from the original design.
One can drill holes in the basement for attaching the device to the layout.
When printing, rotate the lineair servo support by 90 degrees.
Note:
A revised support (Ver 2) with holes for attaching it to a board, has been added. The support bloc for the microswitch is a few mm higher and has pre-perforated holes for the screws.
You may have to shorten the linear bar when installing the items.
1. a revised gear with smaller inner diameter for use on cheap MG90S servo.
2. addition of support for 01 microswitch (use double-side tape or 2mm self tapering screws to attach the MS).
3. this design is on the data of the OMRON SS-5GL micro switch.
The linear bar is from the original design.
One can drill holes in the basement for attaching the device to the layout.
When printing, rotate the lineair servo support by 90 degrees.
Note:
A revised support (Ver 2) with holes for attaching it to a board, has been added. The support bloc for the microswitch is a few mm higher and has pre-perforated holes for the screws.
You may have to shorten the linear bar when installing the items.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!