Thingiverse
Peg Board Mounting
door BigMac9632
2
Downloads
1
Likes
0
Makes
Its a basic design, but it functions as intended, so im fine with it!
Peg hooks are 5.8mm because my pegboard had 6mm holes and they are spaced 25.4mm (1 inch) apart.
I wanted a minimal holes-in-my-wall solution, so a couple of dollar store wooden cubes super glued around the back of the board for support and to space it off the wall, then designed these to match the spacing, boom. works wonderfully for me. Milage may vary, but if it helps others i figure id share it.
Sure, you can just screw the board to the wall, but without space good luck getting anything on it. So this does that while leaving a thinner place still to put your screw or nail and hang it.
Peg hooks are 5.8mm because my pegboard had 6mm holes and they are spaced 25.4mm (1 inch) apart.
I wanted a minimal holes-in-my-wall solution, so a couple of dollar store wooden cubes super glued around the back of the board for support and to space it off the wall, then designed these to match the spacing, boom. works wonderfully for me. Milage may vary, but if it helps others i figure id share it.
Sure, you can just screw the board to the wall, but without space good luck getting anything on it. So this does that while leaving a thinner place still to put your screw or nail and hang it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
