Thingiverse
Peg Board
door ZacharyGardner
29
Downloads
13
Likes
0
Makes
Could not find a fully printable pegboard so i made my own.
Pegboard is 128x128x13mm
Screw size : anything 2.5mm in diameter or smaller should fine, if you want to use a larger screw make sure you use 100 percent infill on the pegboard. Have not tested larger than 2.5mm but should be fine
Pegboard
-Infill : 15
-Supports - No
Pins for Pegboard
-Infill : 50-100
-Supports - no
-Use brim
Little drawer for both
-Infill : 25
-Supports - yes
-Use brim
Pegboard is 128x128x13mm
Screw size : anything 2.5mm in diameter or smaller should fine, if you want to use a larger screw make sure you use 100 percent infill on the pegboard. Have not tested larger than 2.5mm but should be fine
Pegboard
-Infill : 15
-Supports - No
Pins for Pegboard
-Infill : 50-100
-Supports - no
-Use brim
Little drawer for both
-Infill : 25
-Supports - yes
-Use brim
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
