MakerWorld
Organizers
Go to Model
Pegboard Controller Mount Gen 2
73
Downloads
17
Likes
48
Makes
This is a controller pegboard mount. It locks into the pegboard only using 3D printed hardware. It is super strong and cannot fall off, it can easily be removed if you take the locking pin out. Steps to install:Put the hooks into the controller mountSlide the mount onto the pegboard and push it to the bottom of the slotInsert the locking pins into the slotsThis is the second generation of snappegs. See more mounts at www.snappegs.com or https://makerworld.com/en/@ericriley519
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
