Thingiverse
Pegboard hammer holder
by shaune23
103
Downloads
55
Likes
0
Makes
This is a remix of some of mother-of-crafts-3d's work. For my pegboard the pegs were too short to stay in the pegboard so I mashed it up with _____.
Hopefully this rounds out your collection for the peg board.
FYI I printed all of these on their side. If I print them upright, the pieces break between the layers.
Hopefully this rounds out your collection for the peg board.
FYI I printed all of these on their side. If I print them upright, the pieces break between the layers.
shaune23 also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
