Pegboard Hex Driver Holder

The original mount this was remixed from did not include pegs so I added them myself. The original was also not measured for standard, 1/4in pegboard.

I'm also including a closed hole version so you can add your own pegs if you wish.

I printed this with PLA+ laying flat (driver holes facing down just as you would see it on the wall) with supports. This made for a very easy to print and clean, finished product.

NOTE: The 3mm hex driver had some issues fitting the mounting hole but there's enough filament in the driver support that this is easily fixed by drilling it out a bit more. In fact I drilled them all out this way so I wasn't limited to a single spot for the 3mm driver.