Pegboard Holder for Hex Drivers

** [I'm no longer posting any new models of updates to Thingiverse. Please check out my page at https://www.printables.com/social/48520-fuchsr/models]**

Remix of [billiamthesecond's model](https://www.thingiverse.com/thing:3778904). As he hinted at, his model may not work with thicker pegboards, and that was indeed the case for the pegboards on my Seville Classics workbenches because the pegs didn't fit. I also found the holes for the drivers to be a tad too large. So I replaced the pegs with ones I use in my own models of pegboard components and made the holes smaller. I also made the lettering a bit deeper to make it more readable.

This should fit any standard 1'' inch pegboard but then again, thickness and hole size can vary quite a bit between brands.

Technically I guess this model is not a remix but a re-implementation as I started from scratch in Fusion 360. But credit where credit is due, as of course the inspiration for it came from Billiam's model.

UPDATE 10/21/202