PegBoard Holder

I found a Pegboard corner design on Thingiverse (rawkstar320) but the design required 2 different screws and placement was a bit fiddly - so I designed my own which is more straightforward and holds the pegboard more securely.

PegBoard: 4mm plywood, 1230mm x 700mm

Holder can be used for corners and along edges to keep ply straight
Holder is designed for 4mm ply
Holder design gives 6mm between pegboard and wall
3 x centre pieces are attached along the midline of the wall behind the ply to give more support

Used 4mm x 30mm screws

PS final piece also uses rawkstar320 corner pieces (because I had already printed them and didn't want to waste the PLA) but would just use my designs if making again