Pegboard Jig

This is a pegboard jig that will allow you to accurately drill pegboard holes into material with standard metric pegboard sizes (6mm diameter holes spaced at 25mm).

This makes it an effective tool to make pegboards out of scrap material or other materials that you can't usually find pegboards in.

### How to use
1. For the first four starter holes that you drill, it is recommended you clamp the jig to your material. Place the jig with the four guide nubs facing up towards you. Ensure that the jig is square with your material, then guide the drill bit through the four channels to drill your starting holes.
2. Flip the jig over and place the guide nubs into the holes that you just drilled. Now drill out the next set of holes.
3. Repeat step 2 until you reach the end of your material. To guide the next two rows of holes, rotate your jig 90 degrees.

### Some notes
- Due to differences in printer tolerances, you may have trouble fitting the guide nubs into the holes. This is ea