Pegboard Jig

I made this little Jig pattern to mark pegboard holes on a blank sheet of Hardboard.
From centre of hole to next centre of hole is 19 mm.
My Peg board hole (diameter) is 4 mm so I made the 4 pegs 3.7 mm diameter

NOTE: I have found that the pegboard sheets I have encountered are all different sizes dependant on make, please measure your own gap distances before you waste filament.

I did infill to 50% but that was my mistake from last job 20% is fine

So, Mark your First row of holes at the top drill them out and mark and drill with the jig, a really exciting and time consuming job........ not, but will save you a few bob