Thingiverse
Pegboard Large loop holder with support
von jgrasjo
15
Downloads
8
Likes
0
Makes
loop type holder for Peg Board.
designed for a 1" hole spacing
this was inspired by and used the basic peg from Devon at Make anything
Added a downward support so it wont droop if adding a heavier item
the loop diameter is approximately 50mm at the widest point
designed for a 1" hole spacing
this was inspired by and used the basic peg from Devon at Make anything
Added a downward support so it wont droop if adding a heavier item
the loop diameter is approximately 50mm at the widest point
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!