Pegboard Locking Pin, cool design, HELP NEEDED

Pegboard Clips Pins Rivets Remix

To all, this is a WORK in PROGRESS. There are several other projects out there that have done pegboard pins, rivets, clips, etc, and I would like to thank all of them for their projects, mine is built on theirs.

AND, to anyone who is good with OpenSCAD, if you can help ME improve this, to make a parametric version, it is appreciated. I use Sketchup, and I am able to scale these as needed, but an OpenSCAD file would work better.

PROBLEM – all the current Clips/Pins/Rivets are essentially a single diameter. BUT, if you check out pegboards, almost ALL the holes are different sizes. They are usually on 1 inch spacing, but the diameters are all over the place. I have 5 different pegboards I work on, and ALL them are of different diameter holes.

Tool #1 – I have created a set of spacers, ranging from 5.4 mm dia, to 7.0 mm dia, in 0.2 mm increments. This allows me to figure out exactly what pin diameter is needed, for specific pegboard.

Pi