Pegboard Paint Holder Brackets

A system for holding lots of paints up on a peg board with some metal grid shelving my wife had laying around.

I suggest printing it at 100% infill and consider using more than one on each corner depending on the amount of paint you're holding up.

These are still a work in progress but they seem to be working well. Feel free to adapt this or remix it to suit your needs. It's a simple piece.

The first set I made were at 10% infill and they snapped and dumped all my bottles on the table. Luckily there was no damage done and no paint spilled. That is why I suggest making them 100% infill and depending on how much weight you are putting on them you might want to have more than just one on each corner.

The bottom set didn't quite match up, I need to make another model for that I guess. In the mean time I wrapped some duct tape around the bottom set until the weight was settling on them properly.

Working good so far :)