Thingiverse
Pegboard Pin-punch Holder
door rharding13
101
Downloads
63
Likes
0
Makes
A pegboard holder for a set of brass pin-punches.
I have attached four versions:
* With, and without the sizes printed on it, in case your selection of sizes is different from mine.
* With the punches straight up/down, or tilted outwards at a 10 degree angle. Tilting them outwards makes the punches easier to access if there's something else above them on the pegboard.
Mounts on 1/4" pegboard using my [lockable pegboard rivets](https://www.thingiverse.com/thing:4665791).
I have attached four versions:
* With, and without the sizes printed on it, in case your selection of sizes is different from mine.
* With the punches straight up/down, or tilted outwards at a 10 degree angle. Tilting them outwards makes the punches easier to access if there's something else above them on the pegboard.
Mounts on 1/4" pegboard using my [lockable pegboard rivets](https://www.thingiverse.com/thing:4665791).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
