Thingiverse
Pegboard Shelf
by casivido
31
Downloads
109
Likes
0
Makes
It's a shelf. Stable, 90 degrees, pressured between support and pegboard to stay firm.
Designed for 1/4" holes spaced 1" apart. Shelf is 10" wide by 7" deep. Feel free to ask for other dimensions.
No supports needed. PLA 10% is plenty strong, feel free to go higher.
Printing Tip: There's a small lip on 3 of the sides to keep things from sliding off, so make sure the front lip is down on the plate so you don't have a small overhang on top.
Installation: Hooks the supports into the pegboard, I usually only use two although there is a slot for a middle one if more support is needed. Then insert the shelf on top and push it down into the slots.
Designed for 1/4" holes spaced 1" apart. Shelf is 10" wide by 7" deep. Feel free to ask for other dimensions.
No supports needed. PLA 10% is plenty strong, feel free to go higher.
Printing Tip: There's a small lip on 3 of the sides to keep things from sliding off, so make sure the front lip is down on the plate so you don't have a small overhang on top.
Installation: Hooks the supports into the pegboard, I usually only use two although there is a slot for a middle one if more support is needed. Then insert the shelf on top and push it down into the slots.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
