MakerWorld
3D Printer Accessories
Model downloaden
Pegboard Spool Rack
208
Downloads
46
Likes
94
Makes
I have been looking forever for a spool rack for the pegboard in my workshop. Maybe I'm searching wrong or maybe it just doesn't exist… Either way, I found a shelf/rack I liked and remixed it to support a pegboard instead of screwing into a wall. This is also 100% 3D printed with no extra parts. Sure, you could go out and get conduit or wooden dowel, but why when you can print it yourself (if you use the 3mf, just know that I lost a few plates of the 3D printed dowels because the brim wasn't sufficiently large). All you need is a support every 10 to 11 inches/peg spaces, multiple Spool Dowel 1 files, two Spool Dowel 2 files (for one end), and four Spool Dowel Caps. Basically, the order is Cap, 1, 1, 1, … , 2, Cap with a support at the beginning, end, and for every 2 dowels screwed together. NOTE: I tested my P1P's tolerances and ended up only being 0.3mm and couldn't get to 0.2mm tolerance, so the screw threads are 0.3mm smaller than the socket threads. If your tole
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!