Thingiverse
Pegboard Wire Anchor
por Boogiemann
26
Descargas
13
Likes
0
Makes
This anchor was created to hang some decorative lights on my pegboard. This is a lightweight anchor and is not intended for holding extension cords.
This is quite small, so unless you print with 1 wall, it will end up to be 100% filled. I printed with PLA but don't see why ABS or any other materials might not work.
Once printed, simply tug the wire into the slot and snap into the pegboard.
This is quite small, so unless you print with 1 wall, it will end up to be 100% filled. I printed with PLA but don't see why ABS or any other materials might not work.
Once printed, simply tug the wire into the slot and snap into the pegboard.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
