Thingiverse
Pegboard Xbox Controller Holder
door neilgavigan
108
Downloads
84
Likes
1
Makes
Get those Xbox controllers off the ground and in their place. Should work great for XBOX 360 and XBOX ONEcontroillers. A modified "Xbox One Controller and Headset Holder by mikebin41" is the business end of this thing, with a custom-made slider connecting it to a pegboard piece, courtesy of "Pegstr-Pegboard Wizard by mgx."
Xbox One Controller and Headset Holder - https://www.thingiverse.com/thing:2188329
Pegstr - https://www.thingiverse.com/thing:537516
The pegboard side prints as-is, and I don't use supports. Per the Pegstr instructions, print with 4 top/bottom layers and you can just trim off the loose overhang from the upper pegs.
No support needed on the Xbox Controller holder either.
The tolerance on the fit is pretty tight, so you may need to sand/file the interlocking parts just a bit before using.
You can fit together the controller holder and the pegboard piece before you attached it all to your board as one piece.
The pegboard half is interchangeable wit
Xbox One Controller and Headset Holder - https://www.thingiverse.com/thing:2188329
Pegstr - https://www.thingiverse.com/thing:537516
The pegboard side prints as-is, and I don't use supports. Per the Pegstr instructions, print with 4 top/bottom layers and you can just trim off the loose overhang from the upper pegs.
No support needed on the Xbox Controller holder either.
The tolerance on the fit is pretty tight, so you may need to sand/file the interlocking parts just a bit before using.
You can fit together the controller holder and the pegboard piece before you attached it all to your board as one piece.
The pegboard half is interchangeable wit
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!