Pelican case wheels

This is a two part print.
Rim was printed in PLA but other hard material works as well.
Tyre was printed with BIO-TPU as a tyre should be soft, less infill gives softer tyre, everything depends on the load it will carry and your preferences.

there's a clearance of .3mm in diameter between tyre and rim (rim is .3mm smallervthen tyre)

additional needed parts, screw M6 lengt around 70mm and a nut, depending on the suitecase a washer on each side of the wheel might be needed.


If you like what I'm doing, please consider supporting me
https://www.buymeacoffee.com/taguvove