Slicer Discord
Peloton Towel Hook – 3D printable model from Thingiverse Thingiverse

Peloton Towel Hook

by troy_h
232 Downloads
105 Likes
0 Makes
Go to Model
The Peloton has no built-in towel hook. I didn't like hanging my towel on the handlebars because it was in the way of my hands. I tried hanging it on the handlebar adjustment bolt above the water bottle holder but it was awkward to reach it and made it hard to grab a water bottle.

So I designed this towel hook. It is easy to quickly throw the towel on, the towel stays put and it's easy to grab again.

I couldn't find a good way to attach it on the display because it so sleek with no ledges or obvious mounting points. So it takes advantage of the headphone jack on the right side. I use a pair of Bluetooth headphones so I don't use the jack. I cut off an old headphone jack cable, plugged it into the port and the hook has a hole to hang on the short jack.

I also designed a flat section that overhangs the border on the front of the display and used 3M VHB two-sided tape there to secure it and keep it from moving when I put the towel on or take it off.
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

1 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection