Thingiverse
Pen holder
von Cromek
5
Downloads
9
Likes
0
Makes
I needed a simple grip for markers, pens and pencils in the workshop. So there was nothing left for me to design such nice and simple elements.
The width of the holder is adapted to the standard OSB thickness (18 mm). One screw is enough to screw in, because from the side of the board there is a stabilizing performance. You can cut it and use these handles on a flat surface.
I screwed every element with 5x15 mm screws.
I hope you like it an will need such a small thing;)
The width of the holder is adapted to the standard OSB thickness (18 mm). One screw is enough to screw in, because from the side of the board there is a stabilizing performance. You can cut it and use these handles on a flat surface.
I screwed every element with 5x15 mm screws.
I hope you like it an will need such a small thing;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
