Thingiverse
Pen Holder
par Lavre
2
Téléchargements
1
Likes
0
Makes
It´s made out of Petg. Thr settings were :
-80°C bed Temperature
-245°C nozzle Temperature
-Fan Speed 50%
-flowrate 100%
The pen holder is assembled out of 4 parts.
The foot is possible to print with less then 15 percent infill and 0.3 layer hight. It prints relatively fast but the result isnt best quality. For a good finish you have to grind it with, at least 400, for a good surface.
The Holder was printed laying on one side, therefore not much support structure is needed. The Infill percentage has to be over 60 to ensure strong layer adheasion where its needed.
For assembly you need to adjust the foot to the Holder.
The rest is peace of cake, enjoy printing ;)
-80°C bed Temperature
-245°C nozzle Temperature
-Fan Speed 50%
-flowrate 100%
The pen holder is assembled out of 4 parts.
The foot is possible to print with less then 15 percent infill and 0.3 layer hight. It prints relatively fast but the result isnt best quality. For a good finish you have to grind it with, at least 400, for a good surface.
The Holder was printed laying on one side, therefore not much support structure is needed. The Infill percentage has to be over 60 to ensure strong layer adheasion where its needed.
For assembly you need to adjust the foot to the Holder.
The rest is peace of cake, enjoy printing ;)
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !