Thingiverse
Pen Holder
von swademc
1
Downloads
0
Likes
0
Makes
A pen holder with three individual slots. Each slot is 30mm in diameter to fit a maximum of five 'normal' size pens. Three pens tend to 'splay'.
I use it to separate pens and pencils of different line widths.
It can be printed upright at 100% infill without using too much plastic. No support required.
I use it to separate pens and pencils of different line widths.
It can be printed upright at 100% infill without using too much plastic. No support required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
