Pen O Gear

My colleagues say I like screwing around, I say I just like threads!Therefore I present you my Pen-O-Gear, with a pointless winding handle to make those boring meetings pass quicker. There are moments when I like my ballpen end bit to stick out as far as possible, and other times just a wee bit. I couldn't find any pen on the market to satisfy this simple need, so I created this design which I hope you'll enjoy too.It comes with long and short threaded shaft that pushes the Parker refill.If you have access to a computer please try to print the long threaded shaft at 0.16mm or 0.12mm, it runs smoother. Don't be discouraged by the amount of time shown here, if you choose to print one screw and pen at 0.16mm layer height it should take 1 hour and 40 minutes.I added the pointless winding handle and other screws on the second print plate. Tip: look under the print plate to see which one you prefer, and if you're using an app to print this, just print plate no. 1. If this pen