Thingiverse
Pen+Pencil Mount MP Select Mini
par leonhardly
42
Téléchargements
26
Likes
0
Makes
To hold the pen in place you can insert up to two M3 nuts on either side. To hold the mount in place you can also put in an M3 nut at the top once mounted.
Fits pens up to 14mm in diameter. No need to disassemble anything, it fits right over the fan.
No supports needed, check the pictures for the best angle to print it at.
Takes a bit of adjusting to ensure the pen lifts off and back on properly, but once it does it can draw flawlessly!
----
I've added a v2 that suits pencils better. You can put springs in at the top which ensure the nib of a pencil does not break. There is also a better grip system using a single nut on the side.
Fits pens up to 14mm in diameter. No need to disassemble anything, it fits right over the fan.
No supports needed, check the pictures for the best angle to print it at.
Takes a bit of adjusting to ensure the pen lifts off and back on properly, but once it does it can draw flawlessly!
----
I've added a v2 that suits pencils better. You can put springs in at the top which ensure the nib of a pencil does not break. There is also a better grip system using a single nut on the side.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !