MakerWorld
Organizers
Zum Modell
Pencil Case
49
Downloads
40
Likes
16
Makes
Simple pencil Case with build in sockets for vertical pencil and other small thing placement. Idea came from Mom of three kids and who am I to say it's not a great Idea :D. Pencil case is a print in place model. No supports needed. As a locking mechanism I'm Using here four 6x2mm magnets as I didn't want to complicate model with latches and locks. In My opinion Magnets work very good. And to install them just use a very small pinch of supper glue and just be aware of magnet poles to install them in right direction. Profile presented have 4 plates. Two versions of Pencil Case. Dual Color and single color. Both versions have two ways to print. Dual color - with mouse ear disks on all corners and without them Single color - with mouse ear disks on all corners and without them As the printable area on built plate is quite large lift on corners is possible. So to make a bond stronger I do recommend to use them mouse ears. But if You are sure about built plate adhesion in your ca
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!