Pentagon Slice Puzzle

Parts you'll need:
Center x1 (4 pieces in stl)
center pin x1 (split into halves in stl)
Corner x10

Tools you'll need:
Super Glue
File
Flat cutters/Diagonal cutters
something long and rigid (i used the end of my file)

Directions:
Glue each half of the center together and file away any excess flashing. Make sure the halves are lined up perfectly, or the puzzle wont turn properly.

Glue Center pin together and file away until it can turn freely inside the smaller center piece. As well as fit into the hole on the larger center piece. Then insert pin through the hole on the small center piece.

Clean up corner pieces and insert 2 at a time into each center piece until full.

Put glue inside hole on inside of larger center piece in a way where it wont spill out. Push pieces together until dry, pushing the pin in.

Sticker, paint and enjoy