Thingiverse
Peon230 - 35mm Frame Support
von SandroFTW
3
Downloads
1
Likes
0
Makes
I wanted to lower the top plate so I used 35mm standoffs.
After a few crashes my top plate began to get some cracks because the old FPV cam mount wasn't there to support it anymore.
I edited the original one so it doesn't have any screw holes because I just use a simple 3d-printed 25 degree angle and some foam tape to mount my camera to the frame.
After a few crashes my top plate began to get some cracks because the old FPV cam mount wasn't there to support it anymore.
I edited the original one so it doesn't have any screw holes because I just use a simple 3d-printed 25 degree angle and some foam tape to mount my camera to the frame.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!