Thingiverse
Peony Tealight
von threesquare
15
Downloads
78
Likes
0
Makes
It's sort of amazing what you can do with a hunk of plastic: In this case, 3D printing a massive peony tealight.
It comes in two parts: stamens and petals. In this case, I've printed this in clear(ish) ABS, though you can get a similar effect with white PLA.
You can dye your PLA with the usual assortment of fabric dyes for synthetics, though I used an alcohol marker for this print.
It'll fit an electric tealight (Need I remind everyone not to use an open flame around plastic parts? Probably. CYA and all.) measuring about 20mm high and 40mm in diameter (or about 0.8" high and 1.5" in diameter for my fellow Americans).
This is also a bit of beast to print, so be prepared to clear your print schedule.
It comes in two parts: stamens and petals. In this case, I've printed this in clear(ish) ABS, though you can get a similar effect with white PLA.
You can dye your PLA with the usual assortment of fabric dyes for synthetics, though I used an alcohol marker for this print.
It'll fit an electric tealight (Need I remind everyone not to use an open flame around plastic parts? Probably. CYA and all.) measuring about 20mm high and 40mm in diameter (or about 0.8" high and 1.5" in diameter for my fellow Americans).
This is also a bit of beast to print, so be prepared to clear your print schedule.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
