Slicer Discord
Perception Neuron - Neuron Pryer – 3D-Druckmodell von Thingiverse Thingiverse

Perception Neuron - Neuron Pryer

5 Downloads
0 Likes
0 Makes
Zum Modell
So for months I have avoided my Perception Neuron suit. It hasn't performed well due to 4 Neurons being weird and faulty. So today I bit the bullet and grabbed my prop connector and Individually tested and updated all 18 of my Neurons. After an hour or so of testing, updating, more testing I finally was able to Find the Neurons that have been the bane of my existence. But that's not the point of this story today. This post has to do with the god awful pain I received from removing the Neurons over and over again 50+ times. I'm a nail bitter, so I really have no length to my fingernails, so when it came to removing these Neurons so often I was dying from the pain. There were points where I had my girlfriend who has nails try to remove the Neurons and if was still really hard for her.

I like that the Neurons are hard to get out. Snugg fit, I get it. But DAMN... My thumb is still throbbing hours later. So I decided to fix the problem....

I grabbed the dimensions of a Neuron, Tossed
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen