Perfect Draft Handle Cap - Bud

I wanted a selection of different perfect Draft pump tops depending on what I had in them. I do have a few machines, so good to be able to identify them easily. They were printed on a flat plate, to give a better finish and using a 0.2mm nozzle, as the 0.4mm does lose some detail. Although this does take longer, if you print more of the same colours on the same plate you will save time. Colours are aligned as much as possible within the PD caps. So if the design has the same colours, you should be able to print them on the same plateAlso you can always speed up to 124% when you come to the black section. They are fitted with the 5x3mm magnets. The easiest way ive found to install them is. Work out which way the magnet needs to go in. I just dropped it onto the pump top of the perfect draft. Then mark the top of the magnet with a black sharpie, this will help identify which way around, as they can be a little fiddly to fit. Put the magnet over the hole with the sharpie going inside the