Perfect Master Spool V5

This is a simple redesign from scratch of my old spool.it is designed to fit the AMS system of Bambulab.This spool is also used for my own recycled filament.Print settingsboven: Takes about 3 hours on a bambu to print , or around 6 hours on my prusa ( 100mm/s ) onder: Takes about 3 hours to print on my prusa and around 2 hours on the bambuinfill : 10%infill : Adaptive CubeMaterial : Recyled PETG ( or any kind of PETG suggested ) How to use ?when you got your refill you slide it on the big part , then you screw the small part to itbefore you open it , see if you can grab the end of the filament that is on the inside of the refil spoolput that part into the hole that is on the spools in the middle , both sides are fine depending where the end is locatedthen release the zipties and enjoy printingFor technical info please see the PDF file , it shows the dimensions of this spoolSpectsSpool size : 197.77 mmSpool Height : 69.78 mmSpool inside diameter : 79.89 mmEnjoyGreetings from PowerChaosh