Performance Brake Disc/Rotor and Caliper Model

I designed this brake disc largely due to my passion for cars and wanting to both design and print specific parts. This brake disc has a standard diameter of 16cm but can be scaled as long as both print plates are scaled the same as there is a friction fit required. Plate 1 disc has the dowels sticking up which you will need to be careful not to snap off, attaching to the back of the disc in Plate 2. Line up the holes in disc surface and gently attach the two discs. The tolerance is not too tight so if you wanted to remove the two parts again it is possible, but should hold strong enough on its own. Edit: since adding the disc online i have also added a caliper that fits to the disc by simply sliding on, no reprint needed on original disc!